Émilien Varea

Maître de Conférences - Université de Rouen

Groupe de recherche :
Turbulence et mélange

Key Words : Optical diagnostics applied to combustion (high-speed PIV, tomography, OH-PLIF), Laminar premixed flames, flame speed, lifted flames, Lewis Number, Markstein Lengths, Biofuels.

My activities focus on experimental approaches of combustion. Two topics have been particularly investigated during my master’s degree [a] and PhD works [b]. A short description is given below.

[a] Electric fields have long been known to enhance flame stabilization. However, many questions remain and a lot of contradictory results are reported. These contradictions clearly illustrate that the physical processes involved in the combustion enhancement by electric fields are not well understood ; it could also be a modification of the chemistry or the action of an ionic wind on fresh flow. In order to clarify these issues, measurements of OH radical, mixture fraction and fresh gas velocity were performed on lifted propane air flames enhanced or not by an electric field. My work consisted in post-processing sets of data from a previous PhD work (PhD thesis by Karine Criner, Supervisors : Dr. Armelle Cessou and Dr. Pierre Vervisch, CORIA). Specific algorithms were used that enable the automatic extraction of OH radical, which makes it possible to determine the leading edge flame. Conditional measurements of mixture fraction and velocity could then be performed at this position. Specific attention was given to error assessment on mixture fraction (due to filtering process and low signal to noise ratio at stoichiometric value). It was shown that, in both cases, the flame still burns at the stoichiometric value. Also, comparing the two sets of data (flame polarized or not), the electric field makes the velocity in front of the flame decrease, which supports the ionic wind assumption. This work has been published in Experiment in Fluids [1].

[b] The work developed in my PhD focused on the determination of laminar burning velocity. It is well known that laminar burning velocity is a crucial value, very useful for both combustion modelling and kinetics scheme validation and improvement. Experimentally, accurate data are needed. To succeed in this, the spherical flame with constant pressure method was chosen. It allows high pressure, high temperature initial conditions and also, the effect of stretch can be well taken into account. During my PhD work, an experimental apparatus was designed and the automation of acquisition procedure was realised in order to ensure reproducible experiments. In addition, an original post-processing tool coupled with high-accuracy spherical flow field measurement was developed. It is based on the determination of the displacement speed, that is the velocity at which the fresh gases enter in the preheat zone. This pure kinematic measurement ensures an extraction of the laminar burning velocity without introducing any assumption. More details on the technique and also on the validation of the post processing can be found in [2]. Following this work, a second study experimentally determined the laminar burning velocities and Markstein lengths for pressurized isooctane/ethanol/air mixtures using this novel technique. Those mixtures are representative of alternative fuels that can be used in Internal Combustion Engines (ICE). These measurements are crucial for the validation and understanding of the combustion of new fuels in thermodynamic conditions close to those encountered in ICE. The measurements are compared with chemical kinetic mechanisms. This work has been presented and published at the 34th Symposium on Combustion [3]. In spherical geometries, various formulations, analytical or integral, lead to different expressions of the consumption speed. Remaining questions concern the validity of the assumptions induced in the formulation ; for example : adiabaticity, stretch and flame temperature, pressure rise, profile of species in the flame thickness. A comparison of these developments with measurements performed using the kinematic method has been carried out for fuels representative of various Lewis numbers. The limitations of these approaches in terms of assumptions and experimental uncertainties are discussed. A paper is being written on this.

Fichiers ...

CV_Varea

661.3 ko

Mots-Clefs
Catalogue des Documents
CORIA-Lettre
Ecrire au Laboratoire
Flux RSS
Contact & Accès
ACCUEIL
Départements de Recherche du Laboratoire
Activités du département ER
Activités du Département TASC
Activités du Département OL
Informations pratiques concernant les Masters DIODE et EFE
Diagnostic Laser et Métrologie Optique
Où sommes nous ! Plans d’accès. Contact Principaux de l’UMR 6614-CORIA ...
Thèses du Laboratoire. (2002 - ... )
Prochainement en ligne !
This page contains some descriptions of techniques or tools developed for the characterisation of soot particles.
Centre de Combustion Avancée pour l’Aéronautique du Futur
Cavitation et atomisation dans les buses d’injecteurs : étude numérique et expérimentale
Our research activities on ultrafast laser sources, fiber optics and nonlinear dynamics.
Femtosecond and ballistic imaging of high-speed liquid jets and sprays
L’Europe s’engage en Normandie avec le Fond Européen de Développement Régional.
Programme ANR CORIA-EM2C-CERFACS
Agenda
Les Membres
Annuaire
dot : Nouveau

MàJ ··· 14 mai 2019

:::  ico   :::